The Universal Shaft Extender is suitable for steel and graphite shafts
with an internal diameter in the range of 0.475 to 0.585 inches. The
extender is made of a carbon composite plastic stronger than steel.
This extender is conveniently marked at 0.5 inch intervals. The rings
act as a saw blade guide and allow for a clean square cut to be made.

These extenders for standard graphite shafts will lengthen virtually
any golf club. Simply apply epoxy, slide the extender into the shaft
butt, allow the epoxy to cure, and cut to length. Great for salvaging
shafts trimmed by mistake!

The GOLFMECHANIX Aluminum Shaft Extenders for steel
shafts are a major improvement over the double ended
extenders commonly found in the trade. Weighing under
11 grams, our 3" long (75 mm) extenders, are lighter and
straighter, and feature an improved insertion bit 3/4" long
(35 mm) which requires very little adjustment for a tight
and secure fit. For both steel and graphite shafts.